...
If an administrator releases the package from quarantine, recipients receive a message informing them about a new package available for download, as usual. This setting has no effect on that.
(default: disabled)
Notify package sender if a package is quarantined (only registered sender)
...
If an administrator releases the package from quarantine and this setting is enabled, the sender of the package also receives a notification about the release.
(default: enabled)
Other recipients of quarantine notifications
...
The list of e-mail addresses (comma separated), to which to send all notifications about packages containing files matched by the DLP filter.
Approval of sent packages
The following notifications settings will have effect only if it is configured for some users, that their packages have to be approved before being sent out. That is not the default state.
Notify the package sender if sending was approved
Sends a notification to the package sender if his package waiting for approval was approved and sent.
(default: enabled)
Notify the package sender if sending was rejected
Sends a notification to the package sender if his package waiting for approval was rejected and therefore not sent.
(default: enabled)
System notifications
Notification recipients
Comma separated list of e-mails to which notifications about system events enabled below are sent.
(default: disabled)
Notify about package scan failures
Sends a notification if a scan of the package content with detection engines failed.
(default: disabled)
Notify about status changes of long-running tasks
Sends a notification when the status of a long-running task changes.
(default: disabled)
Notify about a detection engine unavailability
Sends a notification if one of the detection engines stops being available.
(default: disabled)
Notify about insufficient disk space
Sends a notification if there is less that 10% of free space on one of disk volumes.
(default: disabled)
Send notification if data integrity corruption is detected
Sends a notification if the data integrity check task detects a data integrity corruption in a package.
(default: disabled)
Notify when the detection engine's quota is exceeded
Sends an alert if the detection engine's licensed quota has been exhausted.
(default: disabled)