Version (v1.3) of FortiSandbox settings

In the FortiSandbox settings dialog it is possible to change the following settings concerning FortiSandbox detection engine:

Maximum file size limit

Specifies the maximum file size for which to perform the check by the engine.

Treat oversize as clean

If this is enabled and the check is skipped because the file is too big, the file is considered “clean” (like if the check was performed and found no problems). If this is disabled, then such file is considered “unclean” (like if the check was performed and found a problem) and the whole package will be quarantined.

Remote access mode

Specifies whether to use HTTP or HTTPS to access the FortiSandbox API. HTTP should be used only in internal networks.

IP address or DNS hostname

IP address or hosname of the FortiSandbox.

TCP port

TCP port on which the FortiSandbox HTTP(S) interface runs.

Username

Username that will be used to access and authenticate to the FortiSandbox API. It is recommended to create a dedicated user for the SOFiE application.

Password

Password, which will be used to authenticate to the FortiSandbox.

Test

Using the Test button it is possible to test the access to the FortiSandbox using the parameters entered above and verify if it works.

This whole settings dialog looks like this:

Open